First, maintenance methods

After each use, the dust, sponge debris and oil and other debris on the surface of the vertical cutting machine should be cleaned in time. You can use a clean rag or compressed air for cleaning.

Regularly clean the inside of the equipment, especially the cutting area and transmission parts, to prevent debris accumulation affecting the performance of the equipment.

Lubrication maintenance

According to the requirements of the equipment manual, the various lubrication points of the opposite cutting machine are lubricated regularly. Common lubrication parts include guide rail, lead screw, gear and so on.

Select the right lubricating oil or grease to ensure that its quality meets the requirements of the equipment to reduce wear and extend the life of the equipment.

Tool maintenance

Check the wear of the cutting tool regularly, if the tool is found to be seriously worn, it should be replaced in time.

To maintain the sharpness of the tool, the tool can be sharpened regularly or treated with the tool grinding equipment.

When installing and removing tools, be careful to avoid damaging tools and equipment.

Electrical system maintenance

Regularly check whether the wiring of the electrical equipment is loose and the contact is good. If there is a problem, it should be dealt with in time to prevent electrical failure.

Clean the dust and debris on the surface of the electrical equipment to maintain good heat dissipation.

Check the insulation performance of electrical equipment to ensure safety and reliability.

Regular inspection and maintenance

Check the cutting machine regularly, including mechanical structure, electrical system, hydraulic system (if any), etc. Discover and eliminate potential faults in time.

Check the accuracy and performance of the equipment, such as cutting dimensional accuracy, cutting surface quality, etc. If there is any problem, it should be adjusted and repaired in time.

Ii. Precautions

Safe operation

The operator must be trained and familiar with the operation method and safety precautions of the vertical cutting machine.

When operating the equipment, strictly follow the operation rules and do not violate the rules.

Wear personal protective equipment, such as hard hats, safety shoes, gloves, etc., to prevent accidents.

Tool installation and replacement

When installing the tool, it is necessary to ensure that the tool is firmly installed and must not be loose.

When replacing the tool, first turn off the power supply of the device, and wait for the device to stop completely before operating.

The choice of cutting tools should be carried out according to the nature and requirements of the cutting material, and inappropriate cutting tools should not be used.

Equipment maintenance and maintenance

Regular maintenance of the cutting machine shall not be delayed or ignored.

When performing equipment maintenance, it is necessary to turn off the power supply of the equipment and hang warning signs such as "No closing".

Maintenance work shall be carried out by full-time personnel, and shall not be repaired and adjusted without authorization.

Working environment

The vertical cutter should be placed in a dry, well-ventilated environment, avoid direct sunlight and humid environment.

The working area should be kept clean and tidy, and no debris should be stacked to ensure the safety of the operator and the normal operation of the equipment.

Fault handling

When the vertical cutter fails, the operation of the equipment should be stopped immediately, and the inspection and maintenance should be carried out.

Do not disassemble the equipment or carry out illegal maintenance without authorization, and contact full-time maintenance personnel to deal with it in time.

Before troubleshooting, do not use the equipment forcibly to avoid further damage.